Traxxas Mid-West TORC R/C Series RD3 held at Bark River International Raceway

I was the top qualifier again for the Mod 2WD Short Course and took second overall.

In 4WD I raced my Mod 2WD in the class and placed second. In Stock Slash I won.

My setup for Stock Slash is exactly that, box stock.

My Mod setup is:

Motor: Tekin Redline Gen2 timing is ABC are lined up with the soldering tabs ABC

Esc: Tekin RS Pro Gen 2 (blinky mode)

Gearing:25/86 slipper 1/4 turn

Chassis: STRC LCG chassis

Camber: front:-1 to -1.5 rear:-1

Toe: front:-1 to 0

Shock mounting ProTrac kit: front lower A-arm outside top mount inside
Rear A-arm is all the way outside top is inside Roll center front with PRO-2 Steering middle hole and on front shock tower middle hole as well Rear roll center is top middle on bearing carrier and lowest hole on shock tower.

Tires/rims/foams: Pro-Line M3 Tazers / TLR dish -fake bead lock rims Losi SCTE offset / Pro-Line closed cell foams

Shocks: Front: Team Associated v1 big bore shocks 37.5 wt fluid with TLR red springs with 2 hole pistons with a preload of 1/4 way down the shaft. Rear: Team Associated v1 big bore shocks 37.5wt fluid TLR yellow springs and 3-hole pistons preload is all the way down.

Diff: MIP ball diff tight then loosened a 1/8th turn

Drive shafts: MIP CVDs Losi XXXSC CVDs for length of ProTrac kit
Servo: Futaba
Controller: spectrum dx3s
Receiver: DX3000T
Battery: Max Amp 100c 5250mah 2cell lipo

– Dylan Hunter